Hi
I have an Intergas HRE 24/28 & was looking to purchase a Nest 3 & I was looking for some advice please
From the reading I have done - I need to ensure there is power to L & N in the Heat Link & wire OT1 & OT2 in the Heat Link to X4 11 & 12 in the boiler - removing any other connections in X4 in the boiler.
I then set the nest to open therm in the settings
This seems fairly simple & I feel like I am missing something
Can anyone advise
Thanks for any help you can give
Many Thanks
Brett
Intergas HRE 24/28 & Nest 3
Moderator: Moderators
- Razor
- Senior Member
- Posts: 8760
- Joined: Wed Nov 14, 2007 10:21 pm
- Location: Northampton
- Has thanked: 483 times
- Been thanked: 1251 times
Re: Intergas HRE 24/28 & Nest 3
It depends how old the boiler is. You don't always remove all other connections on X4 - if it's an ERP model you could disconnect the power to the pump!!
Is the pump round or oblong?
Is the pump round or oblong?
I think I'll take two chickens...
- wine~o
- Senior Member
- Posts: 26169
- Joined: Sat Jan 10, 2009 3:49 pm
- Location: hants/dorset border
- Has thanked: 1413 times
- Been thanked: 3991 times
Re: Intergas HRE 24/28 & Nest 3
I was just about to say Razor will know for sure...
Too slow Wine~o
Too slow Wine~o
Verwood Handyman
_____________________________________________________________________________
If you feel you have benefited from the Free advice given on the Forum, Please consider making a donation to UHM's Nominated charity, read all about it and donate here :
http://www.donnasdreamhouse.co.uk
_____________________________________________________________________________
If you feel you have benefited from the Free advice given on the Forum, Please consider making a donation to UHM's Nominated charity, read all about it and donate here :
http://www.donnasdreamhouse.co.uk
- Razor
- Senior Member
- Posts: 8760
- Joined: Wed Nov 14, 2007 10:21 pm
- Location: Northampton
- Has thanked: 483 times
- Been thanked: 1251 times
Re: Intergas HRE 24/28 & Nest 3
Perfect!!
Leave the link between 4/5 on X4 and remove the old stat wires then proceed as you said in your first post
Leave the link between 4/5 on X4 and remove the old stat wires then proceed as you said in your first post
I think I'll take two chickens...