A while back we bought a TV bracket for a large TV by searching for the TV model number, when it arrived it became obvious that the bracket would not work with the TV, so these stretcher plates, or bracket adaptors were made to enable the bracket would fit the TV. The plates are made from 10mm thick aluminium and took about ½ day to make including painting and filming the video etc.
- Category
- Metalworking videos
- Tags
- TV bracket adapters
Commenting disabled.
Up Next
Autoplay
-
How to chamfer metal
by admin 1,785 Views -
How to fit a shower fixing bracket
by admin 3,785 Views -
Cutting holes in metal using a hole saw
by admin 1,682 Views -
How to make a monitor wall bracket | HP monitor wall bracket
by admin 102 Views -
Unistrut | Vantrunk
by admin 2,048 Views -
How to make small vehicle ramps
by admin 2,323 Views -
Threads in sheet metal | Rivet nuts
by admin 1,600 Views -
How to make a chain anchor point
by admin 1,912 Views -
Drill thin metal using stepdrills
by admin 1,580 Views -
How to drill large holes in metal
by admin 1,741 Views -
How to wire a two way light switch | two way switching
by admin 19.7k Views -
How to identify the switched live wire
by admin 17k Views -
bosch dmf 10 digital detector review
by admin 8,918 Views -
Two way light switching explained
by admin 14.6k Views -
How to find a stud in a stud wall
by admin 6,916 Views -
How to use wall plugs | wall plug tips
by admin 4,084 Views -
how to cut concrete or stone using a chisel
by admin 6,548 Views -
How to use push fit pipe | JG speedfit
by admin 3,330 Views -
Removing a seized tap head gear
by admin 4,584 Views -
How to top up or repressurise a combi boiler
by admin 24.2k Views
Add to playlist
Sorry, only registred users can create playlists.