Parkside Plunge Saw-Not Impressed

This forum is for reviews of Budget power tools such as B&Q / Wickes own brand, Direct power / Titan / challenge / Performance power / Erbauer / Skill/ Bosch Green / Black & Decker

Moderator: Moderators

ahfix
Senior Member
Posts: 284
Joined: Thu Jan 25, 2018 11:25 am
Location: Scotland
Has thanked: 10 times
Been thanked: 66 times

Parkside Plunge Saw-Not Impressed

Post by ahfix » Fri Aug 02, 2019 9:08 am

I got my parkside plunge saw last year so it might be different to this years model.

I've used the stock blade and tracks to cut down a 20mm soft wood table top and square the edges - worked fine (as you'd expect). Also used it a few week ago both cross cut and rip cut old lengths of decking joists (2 x 6 I think) to make a mud kitchen worktop. I did experience some kick back (likely my fault) but otherwise the machine cut fine. I also used the saw to trim the edges to square them up with cuts between 2 - 5 mm and again it was fine. Admittedly I wasn't too concerned about getting very thing 100% square as you would a door.

ah
Post Reply

Return to “budget power tools ”