just had to topup my new boiler because it cut out and was only at 0.3 bar


attached the fill loop turned the screw on the valve for the boiler about 1 turn

then turned the screw for the main a bit and topped it to 1.3 bar and turned off BUT the screw for the valve going into the boiler just turns and turns

I can't take off the fill loop now?

They are quarter turn valve, off is when the slot is diagonal to the pipe.

Post a pic if you have problems

_________________
If you feel you have benefited from the Free advice given on the Forum, Please consider making a donation to UHM's Nominated charity, read all about it and donate here :

donnas-dream-house-charity-t52110.html

so they don't stop when you turn them? they just turn and turn

Some do. Post a pic of the valve.

_________________
If you feel you have benefited from the Free advice given on the Forum, Please consider making a donation to UHM's Nominated charity, read all about it and donate here :

donnas-dream-house-charity-t52110.html

Is that diagonal or 90 degrees Scruff

_________________
As always help on here is free, however if you think you have saved a decent sum of money why not click the link to find out about the charity we're currently supporting? A couple of quid makes a real difference.

donnas-dream-house-charity-t52110.html

Suppose that depends on what school you attended.

A straight line joining two opposite angles in a rectilineal figure.

Works for me.

_________________
If you feel you have benefited from the Free advice given on the Forum, Please consider making a donation to UHM's Nominated charity, read all about it and donate here :

donnas-dream-house-charity-t52110.html

Sorted thanks very much scruff

I just put it back the way it was haha

I thought I had broken it