solder joints solder ring type

Home | A-Z Contents | Arcade| DIY Forum | Directory | Disclaimer | DIY Videos |Safety First | Search

Here we are going to join two copper pipes using Solder ring fittings. These fittings have a ring of solder built into the fitting which melts at temperature and joins the pipe to the fitting. The pipes should be cut as shown here, you will also need some flux and a heat gun/Blowtorch. Please note that plastic pipes cannot be joined this way!Blowtorches and heat guns can be dangerous and can easily start fires, you must ensure that there is nothing close by that can catch fire. A fire resistant mat should be used in areas where the heat from the gun can cause scorching damage to the surrounding area. After using a heat gun, keep checking the area and do not leave the premises until you are certain that there is no chance of a fire breaking out. It is a good idea to have a fire extinguisher nearby as a precaution.

Here you can see the solder ring elbow fitting and the two pipes which are to be connected.

Using some wire wool, clean the two ends of the pipe that are to be inserted into the elbow fitting.

The pipes should be clean and shiny like this.

Now apply some flux paste to the two pipe ends with a brush or clean rag, this will assist in ensuring that the copper pipe is clean to make a sound join.

Insert the two pipes into the fitting ensuring that they are pushed all the way in. You can wipe away any excess flux from the pipes using a rag!

Apply heat to the fitting. Point the flame from the heat gun to the solder ring as this is where the heat is needed

Ensure you apply heat to the fitting in a few different places to ensure that the solder has melted around both pipes

The finished fitting will look like this, check to make sure that the solder has melted and left a ring of solder around both pipes.   Ensure the pipe is flushed thoroughly by allowing water to run through the pipe for at least 5 minutes before any water is used for washing or drinking!